
Many welders get stumped the first time they weld copper pipe fittings.
The base metal looks quite thick, yet after welding, the root is often found to be incompletely penetrated, or the weld is full of porosity. Copper and copper alloys are far more difficult to weld than ordinary low-carbon steel.
Today, let's break down the most common pain points in copper welding and the practical solutions.
Thermal conductivity is too fast, making the root very prone to incomplete penetration
Copper has extremely strong thermal conductivity, about 8 times that of low-carbon steel. During welding, a large amount of heat is quickly carried away by the base metal, so the molten pool struggles to maintain its temperature. The heat at the root of the groove is insufficient, resulting in defects such as lack of fusion and incomplete penetration.
Practical solution: Preheat the workpiece before welding, and appropriately increase the welding current during welding to ensure sufficient heat in the molten pool.
Oxide impurities are easily formed at high temperatures, making the weld brittle
After copper melts, it readily reacts with oxygen in the air to form cuprous oxide. Such impurities remain trapped in the grain boundaries of the weld, reducing the strength of the welded joint, so it is prone to cracking under stress.
Large shrinkage stress increases the risk of weld cracking
Copper has a high coefficient of thermal expansion. During welding, the workpiece expands noticeably as it heats up; when the weld cools and solidifies, it shrinks considerably as well. High welding stresses build up inside the workpiece, greatly increasing the likelihood of workpiece deformation and weld cracking.
Liquid copper easily absorbs gas, forming porosity after cooling
Molten copper readily absorbs gas. When the molten pool gradually cools and solidifies, the gas dissolved inside the metal has no time to escape from the molten pool, and eventually remains in the weld, forming porosity defects.
For copper alloys such as brass and aluminum bronze, the alloying elements within them will also oxidize and burn off at high temperatures, further increasing welding difficulty. Overall, tungsten inert gas (TIG) welding is a relatively reliable choice for welding copper and copper alloys, as it can provide sufficient gas shielding for the weld.
When you weld copper workpieces, which type of problem gives you the most trouble? Feel free to leave a comment and share.
Other Brass Valves from JKL Brass Valve